Coach_McGuirk's latest activity

Yes, R22 in your posted schematic (Kit Rae's R4), but 4k7 is quite large for this resistor when most other Muffs are 2k2 or 3k3. R22...

I use silicone hookup wire and it can be great for reasons that @Diynot mentioned. It can also be a bit trickier to work with if you're...

Is anyone using silicone hookup wire? It seems that the pre-bonded PVC wire that I get from SBP breaks easily. The cheap rolls of...

I built the David Gilmour pedal discussed in this thread. Didn't you say I should *increase* this value though? Should I try decreasing...

If the different pot-taper doesn't fully resolve your problem... To give you an idea of the ranges for those two resistors, I've gone...

Those transistors be like

Good call. This helps a lot. Much more use from the volume knob now. Thanks.

Really though, the reason it works is when you make the TeePee, all those DEVO Energy Domes combine forces to protect your build by...

Use an a100k (audio/log taper) pot instead of the b100k (linear taper) pot for the output volume Will give you the control you need (I...

R21: 12k R22: 4.7k Maybe I'll just stick two trim pots in there? Can I adjust one and not the other, or do they need to remain balanced?

This pedal is far too loud for me. I would like the volume knob to be more operable. What can I change in order to help reduce the output?

The other side is the switch itself. Also, there's much less clearance on the other side, I think.

I don't know what "relatively cheap" is these days but if you're a buy-once-cry-once kind of a person, a BF Princeton Reverb is the...

I see now. You're right.

Worked great! I suppose this could have been done with a single resistor, but I dig the tepee thing. I hope @Robert implements this...