I just finished Chuck's version (thread here) of the Animals Diamond Peak Overdrive and it sounds absolutely killer.
Not a single bad sound in it! Absolutely impressive and a must build for everyone, in my opinion.
It transitions beautifully from clean to dirty, and all controls are very usable.
I had no low gain Si transistors, so I had to use a couple (socketed) 2n3904's, but I'll replace those when I order parts.
I also had to replace the jfet, and gain was lower, but adjusting R2, R4 and C3 I could get close enough in terms of gain and frequency response (or so tells me LTspice).
Outside was linocut printed.
(Album is Ascensão by Black Pantera, a brazilian Crossover Thrash band)
Here are the Spice plots of the jfet substitution: green is the 2n4393 and red is using 2sk246Y (with parameters adjusted to match my measured Vp and Idss)
Not a single bad sound in it! Absolutely impressive and a must build for everyone, in my opinion.
It transitions beautifully from clean to dirty, and all controls are very usable.
I had no low gain Si transistors, so I had to use a couple (socketed) 2n3904's, but I'll replace those when I order parts.
I also had to replace the jfet, and gain was lower, but adjusting R2, R4 and C3 I could get close enough in terms of gain and frequency response (or so tells me LTspice).
Outside was linocut printed.
![1715016267418.png 1715016267418.png](https://forum.pedalpcb.com/data/attachments/74/74674-eed6fdaaac1a1b61998451a231875605.jpg)
![1715016309981.png 1715016309981.png](https://forum.pedalpcb.com/data/attachments/74/74675-a9b4ee003f8c0ca804fc07bb03614415.jpg)
(Album is Ascensão by Black Pantera, a brazilian Crossover Thrash band)
Here are the Spice plots of the jfet substitution: green is the 2n4393 and red is using 2sk246Y (with parameters adjusted to match my measured Vp and Idss)
![1715016464555.png 1715016464555.png](https://forum.pedalpcb.com/data/attachments/74/74677-a8b3ac316461f7dd2feff4df9b4d1a89.jpg)