carlinb17

I built one of these for a fellow TGP member about a month ago and worked on my own when I had the time in the period since. I used...

OK! Tested all of these points for continuity. All were good except the silver/grey points (middle point of boost foot switch to output...

If it’s fake there shouldn’t be any continuity to any other component on the board…

Wrapped this little build up today. I saw someone else's build report recently on this one and I agree on their take as well. The boost...

Carlinb17, Hope this helps explain what you were talking about. Test for Continuity with Matching Colours :

I’m not sure how you ended up there, I had asked you to try a jumper to a suspected trace that seemed it could be bad based upon you...

Sorry erroneous entry… must have been a bot

17

Ok c11 connects directly with r14. can you confirm r13 is the correct value and if so can you confirm continuity between the two ...

I'm not following you, R14 has very low audio correct? Both sides of R14 or just one side? Both sides of C11 sounds fine as well?

Can you believe it? I still had to buy another kajigger to go with that fancy MPLab PM3 programmer… aye aye aye

Free for the asking. The next batch may be printed double-sided….I was so excited ordering the first ones, that when I saw the mockup…I...

I'd also check voltage @ IC1-5. It should be about -9vdc.

those are past R14 on the data sheet. Did you look at the components before R14 on the sheet as indicated above?

Are you able to post clear and complete pictures of the board and connections. Also is the LED turning on?