Recent content by Dameetch

I am not sure because I kind of mangled the cap while I was removing it. What tipped me off is that it was a different color than a prevoius FV-1 build and I know that the 15p value was unique so I only had a bag of a few of those.

I figured it out. I used the wrong capacitor next to the crystal.

Hi, I made a post on r/DIYPedals but had no luck. Figured its worth reposting here - Hi everyone, Having what appears to be a common issue with my hydra delay build. LED turns on. When the mix pot is set to full wet signal, I get nothing. Clean comes through when that pot is turned to anything...

Every few weeks i revisit troubleshooting this pedal - I believe I have narrowed my issue down - When I turn the rate and skew pots, there is no audible change. Has anyone had any issues like this?

I think i spoke too soon. tuning the "gate" trimpot definitely eliminated the distorted sound. but now im not hearing any effect. When I turn the depth knob i hear a change only while turning the knob. the rest of the time im not hearing the chorus at all. Trying to narrow down where the issue...

I know I’m a bit late to respond, but I finally got to tinker more and this was exactly the issue. So thank you for posting this!

Thank you!

Hi All, Building a tear jerker. Went to the link in the building documents to get an enclosure and found that it is discontinued. https://smallbear-electronics.mybigcommerce.com/expression-pedal-shell-kit/ Havent found it elsewhere yet, anyone have any suggestions?

Same issue here. Still not sure where the issue is. been troubleshooting for days.

Hi All, My low tide turns on and seems to work, however when engaged on and at full "mix" the sound just is fuzzy/staticky and inconsistent. When I the mix to just clean it sounds ok. So i am trying to pinpoint where to trace the problem through. Any thoughts on suggestions? Pics attached.

Thank you!

I’m currently building a spirit box. And I don’t have a b2k potentiometer available. What can I substitute? Higher or lower values? That would be for the “depth” control.

I realize this thread is a bit old, but which IC did you end up using that worked?

Done. Thanks for the reminder!

I appreciate the response! Funny, because i made it a point to note the instructions calling out that silk screen issue. Then when the board actually arrived I thought i had rev 2 and didnt think twice about it. Thanks again!