eh là bas ma

Off- topic quick question : Something a little scary just happened to me. I was soldering a socket pad on a pcb, as usual, and...

If i had to do it all over again, i would be more cautious with the rotary switches, and i would use wires instead of jumpers to connect...

For directly transferring the BIN/HEX patch files to a 24LC32A EEPROM, I've found the easiest is to get an EZP2019 SPI Programmer from...

I'm not that familiar with DA's kit but I'm fairly sure a PICKit 2 (or more likely, clone) would work well for programming. Also look...

As some of you may know, unfortunately Cees van Eijk, the designer and brains behind Skidmark Pedals has recently passed away. I've had...

Hello, I am building DeadAstronaut's F-24 Multi-fx project. It's almost done, and i suspect the two EEPROM sent with the kit are empty...

Wait ! I still have a big expensive ring modulator with an issue with the sawtooth VCO waveform ...

looking at that project I'm glad it's marked as solved!! The Aion L4 preamp I made was bad enough!

Your welcome. Finally I could help somone :-) I asked him and he told me that he though tit would fit. I wanted to play around with...

Here’s another one I never got around to posting: the Son of Ben, complete with Fallout graphics and nuclear blast damage. In past J201...

Thank you so much ! A small sheet of paper greatly improves the Manual range, you are right ! I could have done more damage to the...

If manual is only noticable at the higher settings then try to put a small sheet of paper between the led and the resistor. Maybe the...

Hello, this is my second troubleshooting post on this circuit : i thought it was ok, but it's not compared to other builds...

Distortion is just a function of a signal exceeding the clean reproduction capacities/bandwidth of an amplification device/circuit, and...

i think i wasn't clear, sry. The Input Gain control does its job, no issue there. I have distortion appearing during the Manual pot's...