Recent content by Markk

I have 4.5 one one side of r11, then 0.1 on the other..

Thank you sooo much, will check those items and report back!

Muffler noise gate has no effect. I have signal through the circuit, but it's regular clean. Here is my voltage IC pin 1 4.5 Pin 2 4.5 Pin 3 4.4 Pin 4 0v Pin 5 4.3 Pin 6 4.5 Pin 7 4.5 Pin 8 9.1 Q1 Pin 1 3.6 Pin 2 4.1 Pin 3 9.1 Q2 Pin 1 0v Pin 2 0.1v Pin 3 0.2v Q3 Pin 1 4.4 Pin 2 4.5 Pin 3 0.2

Hi fellas, I built a box and all eq into an isosceles boost with an order switch. (Both in same enclosure) In one position of the order switch, I get these crazy high pitch sounds. Also both circuits have level knobs, and they get kinda funky with each other. Does anyone know what I can do...

No it doesn't work

A little bit but not really.

I'm not sure what do you mean

The eq works, the diodes after r22 are LED, they appear to be in the right position.

So I had the wrong cap in c16. Replaced it, getting output but no distortion 🤦‍♂️

Will do, I'll report back when I do.

Yes it dies at r22,

All four ic's read this. 1. 4.5 2. 4.5 3. 4.3 4. 0 5. 4.5 6. 4.5 7. 4.5 8. 9.1

I cannot figure out why the effect doesn't work. In bypass I have signal, the LED works, when I engage the effect, it kills the signal. I have reflown everything, I've tested my resistors, can't figure it out it's driving me mad, please please help!!

So I want to build the ember boost (spark boost clone) with the war sythe (tone reaper), also the oc-2 clone, as well as a green ringer in one enclosure. Any suggestions on how this should be wired? Is there anything special I would need to do in order to make this work? I would like each pcb to...

Mine turned out to be a wrong resistor value at r31. I put in a 470k instead or 470r.