Recent content by mnll

Cool. its a very easy build. I checked out a couple part lists from different sites and they were all about the same. One document had .05uf caps where the pedalpcb version had .047 caps near the output. Smallbears part list had a silver mica cap for the 300pf so i used that instead of a...

I used the audio probe method and turns out a new switch I bought from smallbear was faulty. The clean signal was coming out of the switch fine, but the wet signal part of the switch was busted. The signal coming out of the volume pot was just fine all the way to the switch, so it was...

That blue electrolytic cap in the image was 10uf, to answer your question from earlier. which is what is printed on the pcb. There is a dark blue/purple electrolytic cap on the right side of the ICs and that is a 100uf. All these components are the correct ones according to the pcb and part list.

So checked all my resistor and capacitor values a few times again tonight and those all check out fine. I rotated the input and output jacks to ensure they aren't touching anything. All my solders seem fine and ran some extra solder some of them to be sure. This is probably my 10th build and...

Is that blue electrolytic 100uf? Pretty sure but i will check when i get home. I always double check components when putting them in and then once i was done i checked it again when it wasnt working and appeared fine. Does the tip of your input jack touch the back of the pot when a cable is...

Image

I built the mantle fuzz (blue box) and i can barely hear the effect and my volume pot doesnt seem to do anything. I had tested it with a headphone amp and i had to run a maxed out volume muff into the blue box as a volume boost and turn both the gain and volume on my headphone amp to the...