patgarz

Here’s some pics of my crude decoration. I will eventually drill some spots where I want my LEDS to go but i haven’t decided what color...

Finally got it finished! It seems all roads lead to grounding issues when it comes to troubleshooting a build. I was so intent on trying...

Interesting read, that’s good to know because I am still very rusty as far as reading wiring diagrams goes.

re: the weird IC voltages, that looks like it is correct for this circuit. Ideally, the signal in to an op-amp sits right in between...

Yup that’s definitely a cat hair, it gets everywhere lol. But yeah good shout I think my worst solders are on the switch and jack port...

Its probably a hair or something but is that between your ground lug and the jack connection. You shouldnt have any signal loss in...

Eureka! I added a wire from one of my jacks to the enclosure via copper tape. The signal loss is still present and one side is still...

yeah I’ve done some reading and people basically just say moving the cables away. I’ve tried some combinations but I’ll try a few more...

I tried moving the cables in between the PCB and the enclosure on the pot side, but no difference as far as I can tell as when the...

Hm, don’t have any on hand unfortunately. Just checked the IC’s and still getting weird values on them. Pin 4 is -8.1V and pin 8 is full...

Ah fook, yeah I’m using TL072 per the spec sheet. I saw on the reviews of the PCB that the bias control can get the ticking to go away...

Ok! So the tits were probably shorting. I added some thick paper between the pots and the PCB and now the LFO is not high...

hm that’s a good point, will bend the pots out of the way and see if that changes anything. Also yeah totally agree on GPT, I’ve had...

Hello, This is my first time making a post but I’ve been perusing for a few weeks so hello all. This is my first pedalPCB build but...