Recent content by sndansby

Hi all, I tried building a leprechaun recently and after troubleshooting extensively I ruined the board. I etched the enclosure and I am happy with the results there. I'm not giving up. I am going to attempt this again but the FV-1 has been out of stock. Is there any indication when this is...

Hi all, I tried building a leprechaun recently and after troubleshooting extensively I ruined the board. I etched the enclosure and I am happy with the results there. I'm not giving up. I am going to attempt this again but the FV-1 has been out of stock. Is there any indication when this is...

I am making a few of these and I have a question about the Germanium Diodes. Which diode would work best and where do I source them? Thanks

I am inquiring to find out if there is a service someone here provides that will help troubleshoot issues I am having with two builds. I want to be able to mail the pedals to you and you troubleshoot for a fee, detail what the issue is so I can look out for it in the future, and mail it back to...

I was working on my Muffin Factory and I noticed the diodes I have are listed at 49 HFE and the requirements that are for the pedal are 55-65. Can I use these diodes or do I have to keep looking. Also how can I tell what the CBE leads are?

I was working on my Muffin Factory and I noticed the diodes I have are listed at 49 HFE and the requirements that are for the pedal are 55-65. Can I use these diodes or do I have to keep looking. Also how can I tell what the CBE leads are? Thanks

Hi, I just finished the mini build and I was able to get it working, no minor feet for me. I just plugged it into my amp and I am getting a high piercing tone coming through even when the pedal is not activated. The tone increases in volume when you turn up the Oscillator. Does anyone have...

That sounds great. I haven't tried the soldering legs trick.

I am thinking about building the Dark Rift Delay and I have one question about the where to source the CM1 Pot. Tayda doesn't have them and Mouser doesn't have something with long enough legs as far as I can tell.

I changed out all of the 1u caps. The ones that I had were a large so it doesn't look pretty but those function better. I am still having the issue where I am not getting any other output. I am not getting output from the D100 but I assume that is because it is on the power side of the...

So changing these out would be a good place to start?

I am noticing some of the caps that I used are the 1uF 50V Radial Tantalum Capacitor and some of these seem to be only receiving signal on one side like they are grounded but I do not see this in the schematic. C9, C11, C13, C15, C16 etc. These are polarized caps but I read something that said...

I am not getting signal from the Spectrum or the Dispersion pots.

The ICs are getting signal at the points. Except for the IC4 and IC6.

The leds will light up and I can get audio with the probe at some points.