z2amiller

From the looks of it, the lifted pad will be easy to deal with since it appears that it's connected to the component right beside it...

Good news is, you _should_ be able to see this state of affairs in the UI. After you upload the BOM and CPL files, it shows you a...

The bom looks like: Comment,Designator,Footprint,LCSC,Quantity 10K,"RV1,RV4",RTRIM3362P,C118956,2...

Final Update: I re-flowed all the solder, but it didn't make a difference. I confirmed every component value through visual inspection...

really useful @z2amiller thanks!

I've been adding some THT parts to all of my designs. Sometimes box film caps for larger values, and always JST connectors for the...

Couple of things: - If you have it done with PCBA, to use their 'Economic' service, you'll need to create the panel with mousebites...

Yeah - TL072s are relatively cheap in quantity and they're in almost every pedal. And if they're not in the pedal, a lot of the time...

It's all part of the process... Make sure to order a handful of ICs instead of just one or two. I typically get 10 to 20 op amps each...

I built a board using through-hole components and wanted to see what the JLCPCB assembly would look like for a purely through-hole...

It's possible that's an issue - are the other pin 8's also noisy? (There's a small resistor between which might help the noise though)...

Have you tried an audio probe to see where the signal stops? Especially if no signal even with blend fully dry, that's only part of the...

I haven't gotten this all breadboarded, but I just yolo'ed a through-hole PCB layout and will order a stack of 'em next time I order...

Worst case you can probably just bend those pins out from the socket (cuz you used sockets right?) and bodge it to VREF somewhere. If...

Good catch. That's it. I missed the pin names.