How to wire two separate PCBs into one combo drive?

A

apierz

Member
I want to try putting two of the Arche Boosts into one larger enclosure. It should fit physically, but I wanted to ask about how to wire it. I made an MS Paint showing my best guess:
  • + power jack goes to both + on the PCBs
  • - power jack goes to both - on the PCBs
  • Right sleeve (on diagram) goes to GND on PCB
  • Right Tip goes to switch
  • Right switch goes to left switch
  • Left switch out goes to Left tip
  • Left sleeve goes to GND on PCB
Combo Wiring Diagram.png Any advice or tips on this would be appreciated!
 
Thanks for the super helpful diagram. Do you know if there's any guidance on adding a switch to be able to toggle between which effect goes first? Cheers.
 
Unless I’m misunderstanding, the OP diagram is using two stomp PCBs. There are a couple of ways to wire a 3pdt but they all accomplish the same thing.
 
You must log in or register to reply here.

Similar threads

L
Adding Send/Return Loops to Pro-10
Replies
3
Views
133
manfesto
M
airbud
Combo Pedals - Do I just chain the output to the input of the second one?
Replies
4
Views
219
airbud
airbud
D
Two Pedals One Enclosure ?!
Replies
5
Views
608
HamishR
H
Thommysalami50
2 PCB 1 enclosure with 2x 3PDT breakout boards?
Replies
4
Views
571
Thommysalami50
Thommysalami50
G
Will This Work? (3PDT PCB Question)
Replies
8
Views
386
jwin615
J
Back
Top