DSpenceATL
New member
Ok so I’be scoured the corners of the internet, and whilst I’ve found a good bit of discussion and some videos surrounding LED light plates, I have yet to see a comprehensive guide on how to make them work.
I have a light plate a friend installed on a circulator, and I have the Chuck D. bones throb LED which I would like to illuminate it.
I have drilled a hole in the center of the light plate, but when I put the LED in it and close it up, it’s barely visible. I’ve tried sanding the top and sides of the LED to make it opaque, but saw no real difference.
What am I missing here?
I have a light plate a friend installed on a circulator, and I have the Chuck D. bones throb LED which I would like to illuminate it.
I have drilled a hole in the center of the light plate, but when I put the LED in it and close it up, it’s barely visible. I’ve tried sanding the top and sides of the LED to make it opaque, but saw no real difference.
What am I missing here?