After the success of the mockup, I made some final layout changes and added in a few more features to this "Vintage Edition" Monk Face:
The silkscreen is not actually going to be on the board so it has that clean, vintagey look.
Input control has a space for a 1/4w, 0 ohm jumper to make it a Clean control or a Pre-Gain. Q2 has a space for a 0 ohm jumper or a local feedback resistor so I can do The Fuzz on this board as well.
Spaced for the following:
Vishay/Dale RN55/RN60 resistors
CDE/Mallory 150 series output cap
Xicon 23P Axial Polystyrene
NOS Mial 2.2n for the RF Cap
Piher PT10 Trimmers
Vishay 021ASM Series Electros
I think my MK II will get the same treatment but the board will be a little longer.