What's on the workbench?

[Robert]

It's closer to a stock TS than the GT-OD.

 

[music6000]

View attachment 33978

 

[fig]

Super-Jumbo eh? That's got to be good.

 

[PedalPCB]

 

[PedalPCB]

 

[music6000]

View attachment 34577

 

[benny_profane]

View attachment 34577

POWER SECTION

 

[Robert]

POWER SECTION

Just buy a 1 SPOT.

120mA power consumption and the signal path has one opamp.... seriously....

So we're burning up +100mA for all those jackasses with the wrong power supplies.

 

[Robert]

Seriously though, it's a cool gimmick, but (with through-hole components) unless you want to push a buffer and/or simple opamp overdrive into a 1590XX enclosure we'll probably just stick to plain old ride-or-die 9V negative tip operation.

 

[Laundryroom David]

Super-Jumbo eh? That's got to be good.

Bigger is always bigger

 

[music6000]

View attachment 34577

Maybe like This then?

 

[DAJE]

Super-Jumbo eh? That's got to be good.

I prefer Elite-Petite.

 

[Feral Feline]

I like Reet Petite...

... she's so fine, sssso fy yi yi yi yiiiiiine. Oh oh oh oh, Oh oh oh ohhhhhhh...

 

[DAJE]

I like Reet Petite...

... she's so fine, sssso fy yi yi yi yiiiiiine. Oh oh oh oh, Oh oh oh ohhhhhhh...

The phrase was in my head, but at second-hand: mentioned in the wonderful Jackie Wilson Said by Van Morrison.

I love Van's music but I always feel the need to qualify that by saying I acknowledge that he's a bad person. Better than Eric Clapton, though.

 

[PedalPCB]

 

[PedalPCB]

 

[jesuscrisp]

View attachment 34746

New SMD version I suppose? Got the original release one which still had germanium + LEDs for clipping and OPA2134 op amps (sold it on by now). 2 of the germaniums were dead, which made the clipping really horrible, even by "noise music" standards. After replacing those, I also tried a couple of different op amps and nearly everything sounded better than the stock ones. Attempted a bit of a trace too, topology should be pretty much standard IC Muff or slightly simplified.

 

[music6000]

Funky Like This:



These are subject to Change for the Good of the DIY!

 

[Robert]

New SMD version I suppose? Got the original release one which still had germanium + LEDs for clipping and OPA2134 op amps (sold it on by now).

Yep, it has pads for SMD clipping diodes but none are installed. This one uses a TL074 and apparently has a slightly different Tone switch arrangement than the original.

 

[steviejr92]

View attachment 34726

woah whats that?