Search results

Musikding in Germany? does a lot of full kits with or without unpainted cut enclosures for Aion/PedalPCB/Parasit Studio/ etc etc

Where did you get the PCB?

+1 Mr. Madbean. After I built my Anamorph I gave my AquaDLX to a friend.

If you want to go 1 up from the chickenhead the pedalpcb dragon's breath adds a heat control that adds saturation. It's a clone of the catalinbread naga viper. I built a vero version and love it, except the vero version sometimes has a footswitch popping issue, I've been meaning to replace it...

I did use 1M for the gain. Still tweaking the trim pots lowering the gain here and there, I think q1 to 4 are somewhere between 4.7V - 5.2V now. Turning up the gain slightly I get a mild OD below 9oclock, 9 its hard rock, 9 to 12 its getting crunchy, 12 and over distortion with more...

I replaced C4 with a 10U and it cured the overly brightness

I built one of the blackhatboojum AD9 pcb's and love it. warm with a touch softer repeats than other analog delays I've built biased mine at 550ms.

Great pedal!

Q1 4.6V Q2 5.2V Q3 4.2 Q4 4.6V I built this pedal hoping to get some Soundgarden Superunknowm sounds, after fidding with the bias and controls I've found some settings that nail Spoonman and a few other songs. Someone somewhere suggested 2n5457's, happy I used them. This pedal is a bit...

I just finished the pedalpcb Boogie Monster version, PL uses 100K for all 4 trimpots. My Q4 goes from 2.6v to 9V.

Skoolie! It's on my list.

I have an Anamorph. I could put a fx loop in it. I think I'll put this in the project wish list.

I just built one, highly recommend. Mine is biased at 650ms. I 've tinkered with it up to 810ms but it's a bit wonky that high up. If you want a smaller box madbean has the skoolie board in stock atm.

Are there any delay 's with rng modulation? I was playing around with a delay into my low tide and thought about this.

Try gently wiggling the socketed transistors one at a time, I've had issues with them not being soldered.

I want one!

Reminds me Parasit Studio has a modulation Mod board with a pot for rate and a trim pot depth that could be replaced with 2 wires and an offboard pot. https://parasitstudio.com/shop/Modboard-daughterboard-p752039729 If you look at the build doc this would be easy to add between pt2399 pin6 and...

+1 The Skoolie has a charge pump (15V), input pot and wiggles, and its in stock ATM.

If it works, it WORKS!

Fired up first try after biasing! I think building it over a few months helped. Costly circuit to toss in the fix it later drawer