Search results

Thank Bio77. Voltages all seem to come up normal. I reflowed some questionable solder points, and noticed that the trim pot was starting to come apart. I replaced the trim pot and it started doing its thing! Sounds great. Thanks for your help!

I got a DMM with frequency feature. When I measure pins two and six on the V3207D to ground, I get around 50 or 60 Hz for about two seconds and then it goes right to zero and stays there. Could you please point me to where mad bean’s pork barrel build dock is please? I would like to measure the...

My DMM does not have a frequency function. I think I’ll pick one up this week. I did reflow the transistors. I will measure them later, thank you so much for the tips!

Bottom of board: Link to trim pot adjustment video: https://forum.pedalpcb.com/media/cepheid_no_fx.81/

Thanks! I will pull the board and post a shot when I get back to the shop

You’re right, it is orange orange red. But when put on a meter they read 330K. I think they are NOS resistors but I tested a few of the other others with the same color scheme and they come out as 330K.

Hello I read through some of the other like threads on this issue, but can’t seem to figure mine out. LEDs work, LFO flashes, passes signal, but no effect. Even with slight adjustments to the trim pot, all I get is clean signal, and in some areas of the pot loss of signal. I did have an IC Chip...