Search results

Hello friends. I built the caesar chorus today and on bypass I get a clock noise with the speed of whatever the rate knob is set to. Any ideas? Haven’t tried replacing the chips yet but I have tried different cables and power supplies and powe me cables. Even with no input cable connected, only...

Here’s some shots of the fat general. I used the same transistors the schematic states even though I tried others with varying results. Do yourself a favor and heat shrink the ldr and green led (I used 5mm high intensity clear from Tayda). This gave me the strongest and overall clearest results...

I finally figured out the issues and finished up this build. It's amazing how fine tuned the bias, gain and dry and wet signal mix resistor sections are. I ended up making some minor adjustments to tweak the gain and bias easier and I did the effect (dry/wet) mix trimmer to get a slightly deeper...

Hello brain team, I am getting more of a bitcrush sound with the chorus mode with really low volume. The tone is very flat mid focused as well. When switching to vibrato mode there is no modulation, only the preamp sound. Same tone problems. I’ve made a couple of mids like the faster rate, unity...

Hello brain team, I recently built a skeptical buffer and I’m noticing a small volume dropped when it’s engaged and the toggle switches down. Has anyone noticed if they have any volume increase or decrease? I’ve gone over the values to make sure they are correct and I’ve tried a few different op...

I am working on my second backfeeder. The first one no longer produces feedback (I had to replace a component and I think that damaged the pcb.) Now my current build, there is some static in the background and is mostly heard as the note decays and the guitar volume is quieter. It does this...

Good morning brain trust. I built a Parthenon (Wampler pantheon blues breaker) with all components able to run at 18v. I added a relay latching bypass to it. I'm not sure why I'm getting occasional volume drops (not completely cut out, nor is the pedal losing power) and some volume surges (level...

With the toggle switch in the down position, R101 and C101 short to ground. Up and middle position work fine. I removed the toggle switch to see if that was causing the problem but I get the exact same issue shorting the pads on the pcb. I am so confused because looking at the schematic there is...