Search results

  1. K

    Pro-Ten/Blue _Blinking LED

    I replaced both chips when changing to correct position to be sure. I kept them, that's a good exercise to test them. ;) I'll try tonight. Concerning the pots, I think I have to research how to test them, never done this before.
  2. K

    Pro-Ten/Blue _Blinking LED

    Yes exactly! I changed the order the way you show and have now those weird problems with the volume an treble pots as described. Drive works fine. Any idea what could cause a volume knob behave like this: there’s either no volume, or volume but no increasing of the signal while turning the knob?
  3. K

    Pro-Ten/Blue _Blinking LED

    Oh what a shame :D The pedal works, somehow... The volume knob works, but there's just on or off. The same for tone, there's an a'area' from 9-12ish where it is quite bright, the rest is muddy and dark.
  4. K

    Pro-Ten/Blue _Blinking LED

    Yes that's Ok and works like on this schematic, left and right connected cause wired connection.
  5. K

    Pro-Ten/Blue _Blinking LED

    Hey guys thanks for your help! I also suspected the footswitch at that point. With the multimeter I found that IN & GND were bridged on the pcb and breakout board and I could not solve it. So I decided to place a footswitch without breakout board. IN & GND aren't bridged anymore. I also placed...
  6. K

    Pro-Ten/Blue _Blinking LED

    Yes tried both to be sure ;) Still no sound. I currently have the same problem on two pedals. Sound gets trough, when footswitch engaged the LED is on but the sound is off :(
  7. K

    Pro-Ten/Blue _Blinking LED

    I replaced the ICs and inserted the right way, resoldered the power jack and input output jacks and isolated the LED better. The ON/OFF works fine now, the LED is OFF on OFF and ON on ON. But I can't still get out any signal out of it.
  8. K

    Pro-Ten/Blue _Blinking LED

    Oh hey Jamie, yes that was right. Thanks a lot. Now that I changed the ICs and inserted them the right way, the LED is always on, no matter how often I engage the footswitch. Still no sound.
  9. K

    Pro-Ten/Blue _Blinking LED

    Hi, Does anybody know what could cause this problem: When the pedal is active the led is blinking (on/off in a regular tempo). When volume and tone are turned on max the 'blink' can be heard through the amplifier. The sound of the guitar does not come through. Any ideas?
  10. K

    SOLVED Pro-Ten/Blue Troubleshooting

    Yes I see, the values are not correct. Have to check everything I think. Thanks a lot for your help!!! Measuring every resistor before soldering on pcb next time. :unsure:
  11. K

    SOLVED Pro-Ten/Blue Troubleshooting

    Hey R7 is 220K but R6 and R9 are as you said not 6K8. Will try to unsolder those 2. Thanks a lot
  12. K

    SOLVED Pro-Ten/Blue Troubleshooting

    Thanks Jamie, Why do the solder points on the pots look not good? Just asking to know how to do it right. The pots do all function, but only past 2 o'clock +/-, before that point changes can not be heard.
  13. K

    SOLVED Pro-Ten/Blue Troubleshooting

    Hi, I have a problem with my Pro-Ten build. The pedal seems to work but there's almost no output signal. I have to turn up my amp very hard to hear something, then it sounds thin and also not overdriven. Does anybody have an idea what could cause a problem like this? Thanks a lot in advance, Kaiwa
Back
Top