Search results

Asking for a friend.

I just built one, and I'm not getting audio output. Any update on when the schematic will be released? Thanks.

Can anyone confirm the orientation of the XVive VTL5C4/2 and the CDXL board? Printed letters up or down?

I'm mostly looking for advise on what opto isolator to use. Anyone build one yet?

Do you folks notice a pronounced volume drop when you throw the symm/assymetrical switch upward? Not like a super huge drop, but definitely noticeable and definitely requiring an adjustment to the volume knob?

I don't remember where I read it, but it was here on this forum. It was mentioned that a 1590B enclosure with top jacks was impossible due to space constraints. This inspired me to see if it could be done. To be honest I have come to love the 1590B enclosure, due to its diminutive size, in favor...

If you all know this, please ignore. Regarding the Obsidius Preamp. This is my 10th PCB, and I got into the mindset that resistor hole spacing is 0.300" - which was true up to this point. On the Obsidius preamp, the spacing is 0.200". If you purchase Yageo or similar 1/4 watt resistors, the...

Here is my first build. Not quite complete, but 90%+. What remains is: (1) label the controls, and (2) solder/wire in the 9V battery leads/snap. I had a few goals with this build. 1. Top Jacks. Because that's what the cool kids are doing these days. 2. LED Footstwitch. Because I think it looks...

Does anyone have a source for a 9V power jack that fastens from the outside? By *small* I mean not one of the switching kinds. Something like this but with the nut on the outside: Example Side note: I can't for the life of me understand why the majority (that I am able to find) seem to fasten...

I just completed my first build, the Uberdrive. This is based on the Boss SD-1, which I used to own. I can't compare the two directly (I don't own the SD-1 anymore), but something sounds wrong with my Uberdrive. It's hard to explain, but it sounds like the clean guitar signal is being mixed in...

I searched and searched, but I came up short, so apologies if this is covered elsewhere. I'm trying to make life easier in sourcing the resistors, caps, pots, etc, in a simple and straightforward manner. I am fortunate to have access to a fairly well stocked electronics lab, but they don't have...