REQUEST Aion Spectron & Quadratron

mdc

Well-known member
Hello!
Just curious if anyone's happened to put together drill templates for these projects? I'm about to put a Tayda order in, and I figured I'd ask the crowd before I went ahead and tried to suss it out myself.

Thanks in advance!
 

fydo

Member
I haven't yet tested this (it only recently arrived) but this is my drill template for the Spectron:

(of course, adjust the LED holder holes & power jack holes as needed)

I'll report back if I run into any fitment issues!
 

fydo

Member
Hello, I can confirm that all the potentiometers and switches are in the correct location. I just started on the offboard components today.

The hole for the DC jack is too small and I had to drill it a bit bigger, though.

Have fun with your build!
 

fydo

Member
Hi, sorry for spamming up your thread. I just noticed an issue with the drill template I sent in my first reply.

I hadn't taken the screw posts into consideration and just copied the hole locations from Aion's template, so now my In and Out jacks will not fit.
I'd recommend moving the rear jack holes a little closer together.
 

Attachments

  • photo_2022-09-22_13-12-43.jpg
    photo_2022-09-22_13-12-43.jpg
    223.9 KB · Views: 11
  • Like
Reactions: mdc

Big Monk

Well-known member
Hi, sorry for spamming up your thread. I just noticed an issue with the drill template I sent in my first reply.

I hadn't taken the screw posts into consideration and just copied the hole locations from Aion's template, so now my In and Out jacks will not fit.
I'd recommend moving the rear jack holes a little closer together.

Can you get a box jack to fit there?
 

fydo

Member
Can you get a box jack to fit there?
That's my current plan. Between making the hole slightly larger (horizontally), filing away at the aluminum (but not too much to interfere with the screw post) and shaving down the side of the box jack I think I can make it fit.

Edit: Success!
 
Last edited:
Top