filthmunster
New member
Hi,
I'm getting zero output from the Break Street, however the buffer/bypass works ok.
Some measurements on the quad TL074 opamp:
pin 3 ˜4.38V
pin 10 ˜4.38V
pin 12 ˜0V...
If i measure on the Vref end of R8 i get 0V...
Noticed someone with the same problem in this thread https://forum.pedalpcb.com/threads/break-street-od-how-to-wire-for-tbp.321/
Anybody with a working Break Street OD that can confirm some voltages?
thanks in advance!
I'm getting zero output from the Break Street, however the buffer/bypass works ok.
Some measurements on the quad TL074 opamp:
pin 3 ˜4.38V
pin 10 ˜4.38V
pin 12 ˜0V...
If i measure on the Vref end of R8 i get 0V...
Noticed someone with the same problem in this thread https://forum.pedalpcb.com/threads/break-street-od-how-to-wire-for-tbp.321/
Anybody with a working Break Street OD that can confirm some voltages?
thanks in advance!