Building Dual Effect...Which Toggle Switch Type for Signal Chain Flip?

Hey guys,

Currently making an echo + chorus and I'm looking for some help. I've built a handful of dual effects with a 3pdt signal chain flipper with the help of the pedalpcb breakout board specifically for that. But for room sake, is it possible to do the same with a ON/ON toggle switch? I'm trying to figure out which one that could possibly do this for me.



Well-known member
2 pole double throw will work. Circuit input to center of one pole, circuit output to center of the second.

Effect #1 input to the top of the input pole, effect #1 output to the top of the output pole.

Route effect 2 input/outputs to the bottom. Otherwise same as above.

That will route your signal to one of two circuits, depending on the position of the switch