Conquerer w/transformer

[K Pedals]

Got the new transformer adaptor boards!!!
They work awesome it sounds just as good as the inductors...

 

[chongmagic]

Looks great man, awesome job!

 

[chongmagic]

What transformer did you use?

 

[K Pedals]

Thanks man I used this one

Transformer - Mouser 42TM013

Guitar pedals, pedal parts and electronics.

smallbear-electronics.mybigcommerce.com

 

[chongmagic]

I have been eyeing one of these. How do you like it so far?

 

[K Pedals]

I love it!¡

 

[K Pedals]

I have been eyeing one of these. How do you like it so far?

You haven’t built one yet?¿?

 

[chongmagic]

Not yet, I have one of those transformers, I'll need to get some tranny's.

 

[K Pedals]

Tayda just restocked these they were out

2N4125 Bipolar General Purpose Transistor PNP

Fairchild - Get It Fast - Same Day Shipping

www.taydaelectronics.com

 

[Barry]

Good looking build

 

[eaglehat]

Very cool!

 

[Mourguitars]

Very clean build K Pedals !

Mike

 

[Chuck D. Bones]

Nice build! Good to know that these transformers can replace expensive inductors in at least some circuits. They may or may not work well as subs in waa-waa pedals.

This board has about a dozen unused parts on it. Save some time & money, leave them off.
Q3 and Q7 are wired as a switches that are always on. In the VOX amp that this circuit is copied from, those transistors were controlled by the distortion on/off foot pedal. You can leave out Q3, Q6, Q7, R10, R12, R13, R17 - R19, C7 & C16. Connect a jumper from E to C on Q3. Install a jumper where R13 used to be.

 

[chongmagic]

Does it matter if the primary is oriented up or down when connected to the main PCB?

And did you just use two header pins per side?