Daisy on a breadboard

swetonic

New member
I just got my Daisy (also a Pod), and I tried out some programs already. Very excited to get going.

Can anyone tell me how to get the Daisy set up on a breadboard with 1/4" inputs and outputs, so I can prototype a guitar pedal? I am a software developer by day, so I have the c++ part covered, but I don't have the electronics part covered yet. I'll eventually buy a Terrarium.

I looked at the daisy pinout - would I use pin 16 or 17 for input? 18 or 19 for output? And would those go to the tip of the 1/4" connector? Then where would the sleeve go?

Thanks!
 
Top