Electrovibe Vibe LED

[chongmagic]

So my dumbass got lazy and drilled the LED hole wider and drilled right through the PCB. The board still works but I was wondering if someone could point me to where I need to connect the anode and cathode of the LED on the vibe side since the trace is no longer there?

 

[chongmagic]

Looks like the anode goes to the 4k7 resistor and the cathode goes to ground. It this correct?

 

[chongmagic]

Can someone tell me where on the Vibe board is ground?

 

[Big Monk]

Can someone tell me where on the Vibe board is ground?

Just tap the LED into the footswitch and directly to power. That’s likely easier and cleaner than trying to go to the board if you drilled through.

 

[Big Monk]

One of these should be ground: