Jovi Bon Kenobi
Well-known member
I'm prepping for my next build, the Fuchsia Fuzz, and was just wondering if I did this right as this was the first SMD component I soldered and I used an iron since I don't have a hot air device.
Checking the pinout of the MMBF4393, I used the j201 side of the SOT23 Adapter. Is this correct? And the reading on my meter look ok?
Thanks
Checking the pinout of the MMBF4393, I used the j201 side of the SOT23 Adapter. Is this correct? And the reading on my meter look ok?
Thanks