Caldo71
Active member
Hey folks!
So I took it upon myself to build and wire up a THREE CIRCUIT stomp box—Dwarven Hammer boost, End All Red overdrive, Muzzle gate—into a really large Hammond enclosure.
I wanted it to be a single-switch pedal, so that all three circuits were "always-on", or completely off at the click of a single switch. So, like a maroon, I wired it up like this diagram below, thinking that doing it this way would turn off all circuits together...
...NOT-SO-MUCH!!! As you guys have already guessed, it only turns off the Dwarven Hammer circuit, and the other two circuits stay constantly on.
So I was wondering if one of you fine folks might quickly draw up for me how the wiring SHOULD be on order to do what I was TRYING to do? So as not to be a pain-in-your-asses, attached here is a fully UNWIRED version of the same diagram you can draw all over...
...is anyone game to help me out on this one? THANKS in advance!!!
So I took it upon myself to build and wire up a THREE CIRCUIT stomp box—Dwarven Hammer boost, End All Red overdrive, Muzzle gate—into a really large Hammond enclosure.
I wanted it to be a single-switch pedal, so that all three circuits were "always-on", or completely off at the click of a single switch. So, like a maroon, I wired it up like this diagram below, thinking that doing it this way would turn off all circuits together...
...NOT-SO-MUCH!!! As you guys have already guessed, it only turns off the Dwarven Hammer circuit, and the other two circuits stay constantly on.
So I was wondering if one of you fine folks might quickly draw up for me how the wiring SHOULD be on order to do what I was TRYING to do? So as not to be a pain-in-your-asses, attached here is a fully UNWIRED version of the same diagram you can draw all over...
...is anyone game to help me out on this one? THANKS in advance!!!
Last edited: