Champagneperfume
Member
Hey gang,
I recently was rehousing a completed Duo Phase and replacing the foot switch, and I managed to burn out the IN on one of the areas where the 3pdt connects. Is there a way to bypass the burned off one in the picture in order to make the pedal functional? I'd assume from the IN on the breakout board to where ever the circuit goes to next after the burned out IN on the PCB. Is this logic correct or total non-sense? Help is much appreciated!
I recently was rehousing a completed Duo Phase and replacing the foot switch, and I managed to burn out the IN on one of the areas where the 3pdt connects. Is there a way to bypass the burned off one in the picture in order to make the pedal functional? I'd assume from the IN on the breakout board to where ever the circuit goes to next after the burned out IN on the PCB. Is this logic correct or total non-sense? Help is much appreciated!