Hydra Schematic

Jiuk

Member
I hope to see it. Wet sound is too bright for me so, I want to change to carbon film resistors for FV-1 output. However,, we have not schematic yet.
 

phi1

Active member
@Jiuk I believe the Age pot dampens the highs in the algorithm from what I’ve read on here. Also you could increase c11 to roll off more highs of the wet signal (maybe start experimenting in the 100n - 220n range.
 

Jiuk

Member
@Jiuk I believe the Age pot dampens the highs in the algorithm from what I’ve read on here. Also you could increase c11 to roll off more highs of the wet signal (maybe start experimenting in the 100n - 220n range.
Age pot not helped for me. I only change R17 to carbon film resistor a few minutes before. The result is very very positve.
 

Boba7

New member
Thanks for the schematic! I always like to have them before building a pedal.

Jiuk > what value did you use for R17? A different value probably explains the difference in sound, more than the metal/carbon thing
 

Jiuk

Member
Thanks for the schematic! I always like to have them before building a pedal.

Jiuk > what value did you use for R17? A different value probably explains the difference in sound, more than the metal/carbon thing
Just 1k. I didn't change value.
 
Top