Nick’s Protoboard

[Bricksnbeatles]

Build Rating

5.00 star(s)

Hey everyone! Just finished up my Protoboard today (huge thanks to @fig for hooking me up with some hard-to-find parts)

I got the last two genuine Neutrik jacks from small bear for this.

Red switch cap for power and white for bypass. As with my μProtoboards, I cut a sheet of plexiglass for the breadboards to adhere to, wet sanded the edges to a smooth roundover, and mated the plexi-backed breadboards to the Protoboard with industrial-strength white Velcro, so I can remove them easily to swap out without damaging the breadboard.

Assorted pictures (including step by step of the plexiglass process) below!

Just need to get some feet now, and clean off the flux (I misplaced the isopropyl- whoops!)

https://imgur.com/a/AFIoimt

 

[BuddytheReow]

As @fig would say, "now go build something." I like how this is a build report for future builds, lol

 

[Bricksnbeatles]

As @fig would say, "now go build something." I like how this is a build report for future builds, lol

Indeed! Waiting on some TapLFO chips I ordered to start prototyping a circuit that, thus far, has only been put to paper. In the meantime I have a few other ideas…

 

[andare]

Really nice. Is the breadboard attached to the plexi with the adhesive backing?

 

[Bricksnbeatles]

Really nice. Is the breadboard attached to the plexi with the adhesive backing?

thanks! yup-- breadboard directly adhered to the plexiglass, with loop-side velcro on the back of the plexi