Pin header for Paragon (KOT Clone)

[bzdunowski]

Does anyone know if this https://www.taydaelectronics.com/co...500-2-54mm/wafer-connector-2-54mm-9-pins.html is the “9-pin 2.54mm Male Pin Header” that should be used on this? I have never used a pin header. I built mine like you see in my pic before separating the two pieces.

 

[uranium_jones]

Pretty sure it's this: https://www.taydaelectronics.com/40-pin-2-54-mm-single-row-pin-header-strip.html

Just snap off the right number of pins and you're set.

 

[TheSin]

I just use leftover resistor/doide leg clippings.

 

[Barry]

I just use leftover resistor/doide leg clippings.

Me too, but 9 pins are a lot to line up, I use the headers on my Paragon builds it's much quicker

 

[bzdunowski]

Me too, but 9 pins are a lot to line up, I use the headers on my Paragon builds it's much quicker

can you send me a link to which headers you use

 

[Macca]

can you send me a link to which headers you use

I'm in the middle of a Paragon build and asked this last week. I purchased these headers:

40 Pin 2.54mm Single Row Pin Header Strip

GTK - Get It Fast - Same Day Shipping

www.taydaelectronics.com

 

[Barry]

can you send me a link to which headers you use

The one's Macca posted above