Bobb Lobblaw
New member
Hello all.
Soooo, through a series of self-inflicted solder sucker mishaps, I inadvertently ripped up some of the trace on my Son of Ben pcb. As far as I can tell, it's the trace that goes from the middle pin of the volume pot directly to the pcb's OUT hole. Am I underthinking it, or can I just solder a wire directly from the middle pin of the volume pot to the OUT on the EZ3PDT and keep it moving?
Is there a better way? Would I need wire anything else?
Any and all suggestions welcome. I really like this pedal.
Soooo, through a series of self-inflicted solder sucker mishaps, I inadvertently ripped up some of the trace on my Son of Ben pcb. As far as I can tell, it's the trace that goes from the middle pin of the volume pot directly to the pcb's OUT hole. Am I underthinking it, or can I just solder a wire directly from the middle pin of the volume pot to the OUT on the EZ3PDT and keep it moving?
Is there a better way? Would I need wire anything else?
Any and all suggestions welcome. I really like this pedal.
