Tone pots on protein

[ADAOCE]

I goofed and ordered a B25k and a B20k pot for the tone portion of each circuit. Will the B20k make a huge differenice? Would it be less of an issue on one pedal vs the other?

 

[jhergonz]

I goofed and ordered a B25k and a B20k pot for the tone portion of each circuit. Will the B20k make a huge differenice? Would it be less of an issue on one pedal vs the other?

not that much, but if you don't mind posting a schem, it will help.

 

[ADAOCE]

The schematic isn’t released yet. I built it and it doesn’t make a huge difference I think at least. Thanks!

 

[Feral Feline]

ADAOCE, Did you add a 5k resistor in series to the B20k pot?

 

[ADAOCE]

ADAOCE, Did you add a 5k resistor in series to the B20k pot?

No I didn’t do that I just sent it with the 20k. So I haven’t done any in person comparison I’m mainly comparing what mine sounds like to videos on the pedal
Not a bad idea though because the lower portion of the tone sweep I don’t use.

 

[Jkhicks]

I was about to try this. I can figure out everything except the pot values. Any help is greatly appreciated. Thanks

 

[spi]

The schematic isn’t released yet. I built it and it doesn’t make a huge difference I think at least. Thanks!

There's schematics in the Pro-10 Blue and Pro-10 Green PCBs.

 

[ADAOCE]

I was about to try this. I can figure out everything except the pot values. Any help is greatly appreciated. Thanks

This pot sub is fine. It sounds great to me. I never have the tone knob set to extreme trying to get more out of it.