JimmyS2

Measure on the end of the cable itself.

Take it out of the case again and post close up photos of both sides of the board. Sharp eyed people amaze me with their ability find...

Same here

The S8 manual mentions the polarity conversion cable, but it's a female-male, while the normal cables are male-male. So I assume that...

this has got to be something obviously simple.... Are you 100% confident you are checking your polarity correctly with the multimeter at...

Sounds like a faulty dc jack.

Thanks guys. I re confirmed the power cables are providing the correct polarity, replaced the power jack with a new one, no change. So...

Well, anybody have a suggestion on what else I can check for this one? I didnt expect my first one to work without issue but I do hope...

Interesting. Measuring the cables tip to tip and sleeve to sleeve, they are not polarity reversing. They're all the female to female...

Hopefully these are fairly clear. It looks so much dirtier this close up, I had no idea! I checked out my power supply more closely...

So, I've ruled out reversed power I believe, I can measure about 9v between the sleeve lug of the power jack and any number of ground...

Ok, measuring at the cable shows about -9v, so tip negative I think. It seems I have power when the sleeve of the cable touches the...

Well, the longer (sleeve) lug is connected to positive on the board. I'm sure this is elementary stuff, but my power supply shows tip...

Good afternoon folks, ive found myself in the troubleshooting forum. My first thread here was about sourcing components as I am...

Well, I think I have almost everything in order to build these 3 pedals. I had planned to start with the amentum, as the entire thing...