Latest activity

  • H
    HamishR replied to the thread Guardian OD.
    Guardian pics: You can see my artfully attached .022uF cap on the volume pot lugs. :)
    • Guardian ext.jpg
    • Guardian Int.jpg
  • J
    JoeR3155 replied to the thread Upcoming Releases.
    That's....unbelievable
  • D
    Dirty_Boogie replied to the thread Sea Horse ticking problems.
    I'm thinking power supply. Mine was fine until I reconfigured the 9v runs from my power supply. Will give an update after trying a few...
  • T
    Can you please post the build doc/schematic for this board? Thanks!
  • D
    DGWVI reacted to PedalPCB's post in the thread SansAmp Classic with Like.
    This is definitely on the radar. :)
  • J
    jjjimi84 replied to the thread Caroline Meteore lo-fi reverb.
    Hopefully anyone who clones this pedal can eliminate the horrible noise floor that made this thing almost unusable. I love Caroline...
  • D
    DGWVI replied to the thread Ionosphere issues.
    Thanks for the help, but it turns out the stomp switch was faulty. Swapped that for another 3pdt, and it works as intended
  • D
    DGWVI reacted to zgrav's post in the thread Ionosphere issues with Like.
    check your voltages in the circuit on IC pins 3 and 5. you should put together an audio probe and start investigating the sound levels...
  • F
    Hello, I'm trying to decide on which fuzz to build next, I'm interested in the pyrocumulus fuzz but would like to see a schematic in...
  • Z
    zgrav replied to the thread Ionosphere issues.
    check your voltages in the circuit on IC pins 3 and 5. you should put together an audio probe and start investigating the sound levels...
  • D
    DGWVI replied to the thread Ionosphere issues.
    The circuit only reaches unity gain. Sounds basically like the clean tone, except the tone and volume do effect it. The distortion pot...
  • B
    blivjc replied to the thread Cobalt Drive.
    Thank you for your advice! I will definitely try those. By the way, I just noticed that I made mistake on the post I wanted to say that...
  • Z
    zgrav replied to the thread Cobalt Drive.
    Here are some other things to think about for your troubleshooting --- What sound are you getting at pin 6? Is what you hear at pin...
  • D
    Diatrive reacted to music6000's post in the thread ADHD Tone Knob with Like.
    Also confirm that Tone pot Legs 2 & 3 have Continuity, They are linked via the PCB.
  • D
    Diatrive reacted to zgrav's post in the thread ADHD Tone Knob with Like.
    check to make sure you have the correct value parts in the tone control circuit (c8 and r14) make sure that those parts are well...
Top