szukalski

Try the Diotec BC547A or BC549A. They consistently spec at either 215 or 285 for me and I buy them by the hundreds.

Those are two of my favourite amps ever. The envy is high!

I actually built the electronic parts of these almost a year ago. I built the cabs and then they sat there most of the year as I psyched...

I've farted around with this for a few days, so it's time to share. I'm not done yet, but I'm getting close. Knobs (L-R): LEVEL - TONE...

Had a guy bugging me for weeks about building him a tube preamp/distortion pedal, and to my absolute shock he actually paid once I...

It's a 2018 Tribute. No weight relief or chambering so it weighs a ton.... like it should. :ROFLMAO:

Did you ever have to find a power short circuit on a board with dozens, if not hundreds of little power decoupling caps all over the...

See those little "power flags" in the lower left section? ;)

I've been fiddling with this circuit off and on for over a year. I built the topographer pre (sounds great together) a while back so it...

I don't mind them but my eyesight is rapidly declining, so my opinion might change. Transistors are probably the most finnicky to work...

And here are pix of the two ladies' pedal boards from the Grand Annex show. Gretchen's Angela's

Now, with all of that said... It's an "upside-down" negative ground PNP 'Muff, I don't recall seeing too many of those so that's...

I would like to share my build experience of this pedal. First, i am sorry to hear that those who build this project might have similar...