Recent content by bidurgi999

Since the same problem occurs even after replacing the op-amp, I guess I’ll have to look for another solution. Thank you for your kind response. Have a great day!

모든 노브는 12시 방향으로 설정되어 있으며, 블렌드 노브를 조정해도 같은 결과가 나옵니다. 다른 모든 것은 정상적으로 작동합니다. 납땜 문제일 수 있을까요?

I used a Gibson bridge humbucker, and there’s a Polytune tuner between the guitar and the compressor. I’ll attach a sound file as well.

I built the Median Compressor from PedalPCB. Everything else works fine, but there’s one problem. When I play chords or pick hard, a crackling noise occurs, as if the signal is clipping. Even when I turn down the trimmer, the noise still happens. I set the Q2 bias to 1.85V and I’m using an...

Thanks for the reply — turns out it was totally normal haha. Have a great day!

Hey everyone, I just finished building the Median Compressor, and I’m running into something a bit odd that I wanted to ask about. When I turn the Blend knob, the volume increases up until around 3 o’clock — but once I go past that, the volume actually starts to drop. Is that normal behavior...

저는 페달 DIY 초보자이고 현재 Cleaver Boost를 만들고 있는데, 이에 맞는 Tayda Electronics 드릴 템플릿을 찾을 수 없습니다. 해당 파일을 가지고 계시거나 어디서 구할 수 있는지 아시는 분이 계시다면 정말 감사하겠습니다!