leadfoot's latest activity

Another one that’s been in the backlog for a while. I finally got my 9-pin tube sockets in the mail today, so I finished it right after...

Thanks for the feedback, here's the newest revision. I moved the toggle switches up some, reoriented some resistors and capacitors and...

I forgot the right PCB, it wasn't the pyrocumulus. The examples I had in mind are the Glyph and Trumpeter. PPCB boards rarely stack...

Agreed, I was working on that after posting this last image. It's a never ending improvement cycle... Good idea, I'll take a look at...

Looks pretty good. A few small things. - There's nothing stopping you from rotating q4 so it's oriented the same way as the other...

Sweet sweet sounding tremolo Initially I left the IC pin 6 connected and thought it sounded fine, but after playing around for a bit I...

And here is the near final revision. I'm going to make sure the spacing is 2.54mm between pads on top and bottom, create a sweet...

Devi Ever was infamous for (re)using blocks in their fuzz designs. The Hyperion is very close to two other fuzzes and the switch (being...

Thanks again! KiCAD is definitely a learning curve from EasyEDA where I used to make my PCBs. I'll probably clean up the routes again...

Looks good! The back will be a lot less broken up now. You might be able to spread the top row of resistors apart just a tad to get...

I actually finished this a few days ago but had some gremlins to work out. Tip, use pot protectors, lol. They were fine out of the box...

After @z2amiller's feedback, here's the next revision. I also added a pull-down resistor. Once the routing looks good, I'll work on...

One more! This time with a switch to defeat the octave. Great enclosure by @mwpedalparts-maggie! Sounds really good, I went with a combo...

Nice! I'm no expert so take all of this with a grain of salt. I also mostly route SMD layouts but I think most of the advice will...

it's basically the GGG schematic, but has 9V (100-220uf) filtering, uses 2N5089 transistors, and has a tone bypass. i built mine using...