Passinwind's latest activity

I searched on 'tray' but didn't see a thread with photos. I used an oven tray with a sheet metal lid to get rid of the noise completely...

Hammond? https://www.hammfg.com/electronics/small-case/rack-mount/rm

My go-to vendors: http://www.par-metal.com/ http://www.modu.it/homeeng.html

I’ve been doing HPFs in most of my DIY bass amps and preamps for many years, usually with a bit steeper slope than Josh uses though...

Yeah uprights have to battle a lot of sub. Hence the broughton high passes everywhere

With a piezo lower Z loading tends to cut the lowest bass octave, which is not necessarily a bad thing for AUB. Especially with my...

They aren't cheap that's for sure. I always see 10Meg quoted for uprights but I'd bet that is overkill.

The last acoustic upright pedal I did for a friend which had a Fishman BP100 pickup system ended up sounding best to us at ~700k, which...

Not yet, but I’d probably use one of my higher impedance open source preamp pedals as a front end, or maybe the 10meg Creation Labs...

Hm, quite the opposite of what I was thinking but it makes sense. Lo z lowers the q of the pickup. Granted that can come with its own...

My new DIY tube bass amp is actually getting a switch like that this week. Since I only play active basses I started with a 100k input...

Like medium to lo-z inpits? It's an interesting concept if so. Probably enhances the character of each instrument. It's interesting...

Yep, killing/neutering the pickups natural resonant peak with a tailored Z load so you can impose a variable one with a resonat LPF, for...

Yes, that works...;)

I perused around the DaisySeed sub forum and read there is now a DaisySeed 3. I ordered a few. I’ll try swapping it out to see if it...