phi1's latest activity

This picture how you have it? The build doc says diode OR LEDs looks like you have both in that spot

You could just try swapping the led wires to change the orientation of the led and see if it’s lighting. This shows the case where the...

Is the led in the opposition orientation from the 1n4148? LED has a higher forward voltage (threshold before it clips). If they’re the...

Nice. If you want 2 diodes to change the clipping threshold, you have to put 2 in series (same direction). (Looks like you have 2 diodes...

Some reference info - handwriting fv-1 code is a whole learning curve. You can also use SpinCad (by digital Larry) to generate code from...

Thank you so much for writing that out. I'll check out electrosmash, and that freq analyzer site is awesome!

A lot of it comes down to: -high frequencies go right through a capacitor, almost as if it was a short. -low frequencies see a capacitor...

Love to see the mods and the creativity!

I think the Fascist Pumpkin needs to be a lot messier inside. It's too well laid out and makes sense. To be a true statement it...

Hi you wonderful community. This hobby has brought me so much joy the last 3 months I figured I'd shared with you all some of my...

I think we're being a little over critical of the guy here. I think he was just feeling the grief of a failed venture and wanted to...

The whole post reads a little like “I’ve put all this effort in and expect ppl to want to buy my pedals” - I think it’s a bit mad, like...

Pt2399 is run off a 5v power supply, so with a hot enough signal it could clip. I know I’ve had a Belton brick reverb clip on me (which...

Lots of nice articles on this site. https://www.coda-effects.com/2018/08/the-different-types-of-diodes.html For more lows, you could...

Old article, but still a fun read. Mod 4 (transparent tone control) looks cool...