SamuelG's latest activity

The Fc of 180Hz has been my favourite for Bass. It's a very low slope but still removes the mud.

So, in terms of simply bending the pin, that would work well. However, I needed to cut Pin 3 because I had already installed the module...

Good question, I’ll check my notes. My current build has a 1uF in place.

So, after a pause to re-do my Bathtub Reverb MOD, I've now integrated the idea above [thanks Mick]. I have adjusted the circuit so...

Yes. It's what I used for all of the builds.

Note that I shorten pin 3, then mount pin 3 to the board via the 0.015uF cap. All of my shileded cables are grounded to pin 4. Next time...

Two reasons for the high C2. The main one being, that's what I had on hand :) The second is that I tend to let pedals have a specific...

Oh, a C2 of 0.68uF also works and will give an Fc of ~15Hz but I didn't have one on hand.

Okay so after three different itterations I'm finally happy. To replace C2, I put in a 1uF 400V cap mounted on the underside. [Not...

I’m now working on applying the Fc switch to the wet signal but not the the dry path. Been busy lately so slow progress.