Yeah I lean towards medium gain transparent overdrives. I go and build a high gain chugg-ah beast and then immediately try to change it?!?
Good thing I have time to waste huh?
You looking at the Tyrian schematic? The resistor #s don't look right.
Thanks Chuck D.
I made the below changes.
I replaced R22 with a 10K which moved the Freq. cutoff of R22&C16 low pass from 3.3kHz to 1.5kHz. This produced a noticeable reduction in overall highs. Why such a high cut off freq there?
I replaced R23 with a 22K which moved the Freq. cutoff of...
Hey folks!
I just built a Tyrian using a Hammond 1590B3 enclosure. First kit I've built from Pedal PCB and have nothing but praise for the products and the community here. The reason I went with the 1590B3 was to get a slightly lower height profile at the expense of increased width. I think...