Recent content by smalltownsongs

Thank you! I used the Tayda Drill Template and their UV Print service as a test tryout. Turned out better than expected! But it did take.... forever :eek:

Thank you both SO very much! @falco_femoralis I changed out the other two sockets just cause I could.... and VOILA. We have a working, non-scratchy Kliche! This is the ~15% that wasn't a grounded-out dual gang, but rather using substandard parts. While I do feel a bit foolish there, I'm sure...

OK, we're getting somewhere here... where, I don't quite know, but perhaps somewhere. I unplugged power (I'm using the PedalPCB auditorium rig for power at the moment), and pulled IC1 and IC2. Plugged the power back in and Pin #3 and #5 for IC2 are 4.7V however... Pin #3 for IC1 is whack. It...

Thanks, the socket being a problem makes sense to me, as I didn't have the regular sockets I prefer and used ones that I kinda hate. To clarify, should there be continuity at all? Thanks!

I'd checked the dual-gang as that seemed to be the most popular issue. It's not touching, and I've actually used a half of a guitar pick to put in the gap as a shim of sorts when I had it boxed. This issue is still happening "outside" of the enclosure, no dual-gang touchy-touchy. I won't rule...

These are all good and proper, thank you for the suggestions!

OOoh, yes, that was another plan too. I've not used one to date, but will do some searching.

Hey all! Well over 50 builds under my belt, including quite a few klones, but this is my first self-unsolvable issue, so I figured I'd post up and graciously ask if y'all could see something I'm just missing. :) Engaged, it's loud and sounds pretty good (I might say it's not as overdriven as...

Most wonderful, thanks!

Hello all, Building up the VHS, but don't want the chorus. Just Reverb and Boost. Anything special I should do with the switch portion for Chorus (jumper, leave alone, etc), or anything else I should be mindful of? Already planning to wire it "always on" and use the dpdt's for Reverb and Booost...

Pretty similar idea here, follow this dude's creative YT for some of the most.. um... interesting voiceover... I've tried this, it works, but would much rather stick with laser printed waterslides