szukalski

Here's my Churl of Toan. I've been try to declutter most of my infrequently used pedals, but I've held on to my Pauper (Prince of...

Its been mentioned a few times already, and I'll mention it again. An audio probe is the next step. Trace the schematic from jack in to...

Prices will not come down again. Number only go up

This one's done. I tried some clipping options on the 1st stage just for S&G, but there were no improvements to be had.

This circuit came from a TWOBB thread from the time frame when I was on my hiatus. So I missed it originally. I wasn't completely sold...

You can find it here: https://sheepylove.com/products/wise-ass-yabb

Where can one find the original project I can’t find it in the shop.

IC3 can be a TL072, then you can swap opamps between all 3 devices. Not recommending it, just saying it's possible.

I would not use the same device for the 1st and last stage because I want to keep input and output as far apart as possible. Many...

What about changing the opamp order? IC1A -> IC2A -> IC2B -> IC1B

Yeah, I know.. but it's a bit easier to have a neat signal path/layout this way. :)

I got a handful of boards for some new sheepy love circuits courtesy of @MichaelW. Mike also sorted my smd jfets and used his new easy...

This pedal has received some rave reviews in the Build Reports forum, so I had to breadboard it and see what it was all about. The...

Boneyard Emperor of Tone lead channel (without charge pump): Y.O.S. Smoggy. YATS. Footswitch with LED: LPD Sixty8 with Boneyard mods:

Great build. You can add a 4k7 resistor between the 2nd leg of the pot and the board if you want to stop the LFO bottoming out when the...