temol's latest activity

Arachnid (8 programs) or Pythagoras (3 programs). Also eeprom programmer and then you can use available FV-1 programs or buy...

Yep, it's correct. But there are different adapter boards available. For example: Remove Q2 + Q3 and measure the voltages. Then maybe...

Hm.. I think a photo will be needed after all - show a close-up of the transistor adapter boards. It can be a board without a...

C10 is optional, should not affect normal operation. Is it the same when you desolder the LED? or desolder IN/OUT/GND/SW wires from...

I know that picture is worth thousand words but here we prefer measurements.. Time to measure some voltages. Take the multimeter, set...

Cnc...? Using "regular" metal stamps is possible for single letters, or for punching out letters one after another. If you put several...

Got some heavier gauge solid bus wire from Amplified Parts and felt the urge to try my hand building one of those again. This time I...

Make sure R16 is 33k. Should be orange-orange-black-red, but to me it looks like orange-orange-black-brown which is 3k3.

So now you can: - inspect the pcb.. is there any missing solder joint? Or maybe cold solder joint? - resolder those two solder joints -...

Make sure you have a continuity between pin 6 of the IC1.2 and R17. Same with R17 and pin 1 of the Gain pot. Then Pin2 of the pot and...

Not strictly pedal related, but definitely helpful info.

I had a similar feeling for a moment. These photos are very sterile. Zero imperfections.