Search results

  1. T

    Is it ok to have copper pours with deviations and edges like this?

    The Vias anti padding is creating these crazy edge shapes on my copper pours and I don't know if thats ok to send off to a manufacturer How is this supposed to be done professionally?
  2. T

    Feast your eyes on my beautiful SPI BUS

    STM32WB55CGU6T = MASTER ADS1299 = SLAVE 400ps rise time before I added 100ohm Resistors. Estimated new rise time = 2ns Clock Speed = All I need is 100 KHz max Full Ground plane .11mm under as reference Grid increments .750mm Via sizes = Big .3 x .6mm and Small .45x .2mm
  3. T

    Am I doing SPI connections and stitching vias correctly?

    SPI trace length < 9mm SPI Via size 0.3mm x 0.6mm Stitching Ground Via Size 0.2mm x 0.4mm I'm estimating .5ns or 500ps rise time Frequency estimate 2-3 GHZ I did the best I can I don't know if there is something I could be doing better. I would like to reduce noise as much as...
  4. T

    MCU and RF module are both NRF5340. Do I need both or should I just use the RF module as MCU and RF Transmitter?

    Very sensitive Mixed signal PCB. EEG (Brain wave sensor). 0.010mv sensitivity I have seen multiple examples of EEG PCB's where they have a MCU and a separate RF module. Considering the fact that the RF module (MDBT53) is literally a NRF5340 with an antenna, should I just use that to...
  5. T

    I'm combining 2 ground planes. Analog and Digital. What potential problems can happen?

    AGND AND DGND BOTH ARE FULL PLANES TAKING UP THE ENTIRE SPACE OF THE BOARD COLORED OUTLINES ARE JUST WHERE COMPONENTS WILL CONNECT TO THEIR RESPECTIVE GND'S TOP LEFT WHITE ARROW IS POINTING TO NET TIE'S CONNECTING ANALOG AND DIGITAL GROUND ONLY IN THAT AREA OF THE BOARD The ic on the top...
  6. T

    How do I make a via connect Ground 1 and Ground 2 planes without making them the same NET?

    GND and GND2 are 2 different ground planes with their own net. I have it like that on purpose to control return paths in different areas. I just want to connect them in this area but Kicad wont let me connect to planes with different via names. How am I supposed to do this?
  7. T

    Do Intersecting SPI signal return paths cause major issues or do they kind of just pass through each other like light?

    Ads1299 on left. MCU input pins on right. SPI signals going between them on layer 1 Layer 2 is a ground plane 0.11mm dielectric between planes Frequency of signals is around 60mhz. 8ns rise time. DOUT is GREEN and returns to DGND pin on the ADS1299 DIN is BLUE and returns the the...
  8. T

    How Good Is Faraday Tape?

    Does anyone have experience with faraday tape and is it good enough to block the signals in this video down to under 20uv, or .02mv if all exposed metal with signals running through it are covered?
  9. T

    Assuming DOUT and Din (red traces on right side) are at 10ghz, Will emi interfere with electrode inputs on the left?

Back
Top