Search results

  1. N

    Trying to layout a muff on the breadboard

    It's a little abstract for me to understand, but am I doing this right? I'm following this schematic, http://www.bigmuffpage.com/images/KR_1973_V2_No%203%20Schematic.jpg
  2. N

    Clipping switch? Mosfets as clipping diodes?

    So I'm working on the Chela OD,how would I use mosfets as clippers? I want to wire a switch between the regular clipping (red LED) to mosfets for a different, softer attack/clipping.
  3. N

    Having trouble tinning tip, melt solder not consistent.

    So I have a weller soldering station. I have the heat set around 660f, and it is not tinning no matter what I do. I clean the tip with flux, then attempt to tin in, all the solder rolls of and I still have a tip that doesn't conduct heat very well.
  4. N

    Build wont pass signal, LED doesn't light, basically nothing.

    So I used one of the breakout boards for the switch, and have a el sol not showing any signs of life. I'm ok if it's a write off but wondering what y'all think. I think before I realized My iron wasnt tinned I may have lifted some traces.. but even if the board didn't work, shouldn't my LED...
Back
Top