Matopotato
Active member
Does anybody know @Robert 's plans for an updated PCB of the Backfeeder?
I just managed (somehow) to order a kit from Das Musikding, but I am assuming this is the older PCB that is out of stock.
So what changes are planned for the upcoming release?
Might be able to include them anyway.
I am already planning to lift the C17 220nF cap from its ground point and put in an SPDT on/off/on with the C17 leg on lug 2 and one wire to DC jack ground and another to either the C17 ground on the PCB, or if that is to ground plane, then instead take the wire to pin8 of the 4046 for in total 3 different results...
I just managed (somehow) to order a kit from Das Musikding, but I am assuming this is the older PCB that is out of stock.
So what changes are planned for the upcoming release?
Might be able to include them anyway.
I am already planning to lift the C17 220nF cap from its ground point and put in an SPDT on/off/on with the C17 leg on lug 2 and one wire to DC jack ground and another to either the C17 ground on the PCB, or if that is to ground plane, then instead take the wire to pin8 of the 4046 for in total 3 different results...