Matopotato
Active member
I looked through the Dandy Horse project to figure out where the bypass/on-off led goes and its LEDR. But I couldn't find it in docs or pics here nor on the PCB. Is it just manually set on the 3PDT?
There was a location on the drill template so I assumed it would be on the PCB.
I also saw the option of putting an LED + 2k7 from IC8, pin 14 to ground for rate LED, and that might make the bypass one redundant. Haven't quie decided yet.
There was a location on the drill template so I assumed it would be on the PCB.
I also saw the option of putting an LED + 2k7 from IC8, pin 14 to ground for rate LED, and that might make the bypass one redundant. Haven't quie decided yet.
