footswitch soldering problem?

[blokenator]

hi all!

i have this 9 pin footswith i did solder to the pcb. I thought in the moment that all 9 finns should be soldered to the pcb, but that was probably wrong
because the pedal is totally dead. no led ligt not sound no nothing. I hope some one has time to answer this silly rookie question!

cheers

 

[RetiredUnit1]

hi all!

i have this 9 pin footswith i did solder to the pcb. I thought in the moment that all 9 finns should be soldered to the pcb, but that was probably wrong
because the pedal is totally dead. no led ligt not sound no nothing. I hope some one has time to answer this silly rookie question!

cheers

What is the name of the pedal, and got any pictures?

Did you follow the wiring diagram?

 

[giovanni]

I suggest starting a troubleshooting thread with lots of clear pictures of the board and wiring.

 

[jwin615]

Check with a multimeter on resistance or diode setting.
You should get a beep or near 0 ohms between the ceter lug and top OR bottom lug but not the top AND bottom lug.
So 12, 45, 78 then switched 23 56 89
Nothing between 12 46 79

 

[blokenator]

Azure Analog Chorus is the pedal. I hade quite good control over the soldering and wireing should be ok. it was that switch that made confused, thougt if I solder all 9pins the one not in use cant do any harm, but might have done

 

[notTHEwillienelson]

Azure Analog Chorus is the pedal. I hade quite good control over the soldering and wireing should be ok. it was that switch that made confused, thougt if I solder all 9pins the one not in use cant do any harm, but might have done

Aionfx kit version, I'm assuming. Please provide clear pictures of the entire thing (both boards and wiring). I doubt the footswitch is the issue.